D P R A - 2 1 2 1 5 T R A V E L . X P IBM
Native| Translation
------+-----+-----+-----
Form 2.5"/SUPERSLIMLINE Cylinders | 2358| |
Capacity form/unform 1200/ MB Heads | 16| |
Seek time / track 12.0/ 4.0 ms Sector/track | 63| |
Controller IDE / ATA2 FAST/ENHA Precompensation
Cache/Buffer 64 KB READ/WRITE Landing Zone
Data transfer rate 5.000 MB/S int Bytes/Sector 512
11.100 MB/S ext PIO3
Recording method operating | non-operating
-------------+--------------
Supply voltage 5 V Temperature *C 5 55 | -40 65
Power: sleep 0.1 W Humidity % 8 90 | 5 95
standby 0.3 W Altitude km -0.300 3.000| -0.300 12.000
idle 1.3 W Shock g 100 | 300
seek 2.6 W Rotation RPM 4900
read/write 2.6 W Acoustic dBA
spin-up W ECC Bit 128BIT REED SOLOMON,ENHANC...
MTBF h 300000
Warranty Month
Lift/Lock/Park YES Certificates
**********************************************************************
L A Y O U T
**********************************************************************
IBM DPRA-20810/21215 TRAVELSTAR XP JUMPER SETTING
+--------------------------------------+
| |
| |
| |
+--------Interface-------------47------+
| **********************1 **45 Jumper
| *************x********* **46 |
+------44----------------------48------+
+ +
Pin position 20 is left blank for secure connector insertion.
Pin position 45 through 48 are used for drive address setting.
**********************************************************************
J U M P E R S
**********************************************************************
IBM DPRA-20810/21215 JUMPER SETTING
Jumper Setting
==============
Drive address
-------------
A jumper is available at the interface connector to determine the
drive address.
Using Cable Selection, the drive address depends on the condition of
pin 28 of the AT interface cable. In the case when pin 28 is ground
or low, the drive is a Master. If pin 28 is open or high level, the
drive is a Slave.
---47--45+
* * X | Master
* * X | (Default setting)
---48--46+
---47--45+
* * * | Slave
* * * | No Jumper
---48--46+
---47--45+
* * * | Cable Selection
* xxx |
---48--46+
**********************************************************************
I N S T A L L
**********************************************************************
-ANY DIREC.
Notes on installation
=====================
Installation direction
----------------------
horizontally vertically
+-----------------+ +--+ +--+
| | | +-----+ +-----+ |
| | | | | | | |
+-+-----------------+-+ | | | | | |
+---------------------+ | | | | | |
| | | | | |
| | | | | |
+---------------------+ | +-----+ +-----+ |
+-+-----------------+-+ +--+ +--+
| |
| |
+-----------------+
The drive will operate in all axis (6 directions).