10/08/96	


For reliable operation your Data and Fax software
must be set for Hardware Flow Control. 

Please follow the instructions in the Installation Guide
to install the software to be used with Windows95.

The default IRQ is IRQ 3.
 
After the setup program successfully installs the software drivers,
you must reboot windows to activate the modem in order to use it.


Please be careful when you install the modem on Windows95            
                                                                               
The IBM HPC modem requires the right device driver when       
installed to your PC. Any of the device drivers included in the original       
Windows95 will not work with the modem. The diskette in the carton contains   
the right modem driver. Please follow the instructions in the 
Installation Guide to install the driver from the diskette.                                          
                                                                               
If you have already installed a wrong driver, please follow the steps
below to remove the wrong driver from your system and
follow the Users Guide to install the correct driver.                                                              
                                                                               
1. Insert the modem card.                                                               

2. Go to Windows95 Control Panel, click the System icon.                      

3. On the System Property windows, click the Device Manager tab.               

4. Double click the Modem icon so that you can see the wrong
   modem driver icon.

5. Select the driver icon and remove it by clicking Remove button at the       
   bottom of the windows.                                                         

6. Click OK to close the System Property windows.

7.  Then, follow the instructions in the Installation Guide to install the
    correct driver from the diskette.