IBM ThinkPad 240                                       December 02, 1999
Command Prompt Utility for Windows NT 4.0

Version 1.02
========================================================================

Notice:
-------
- This program is language independent and can be used with any language
  system.
- This version of the Command Prompt Utility is dependent upon the BIOS
  version. Check your BIOS version and if necessary, update the BIOS.
  The BIOS which supports the Command Prompt Utility is as follows.

  BIOS Version                  System Program Service Diskette Version
  ---------------------------   ---------------------------------------
  IRET62WW, or                  1.08 or higher
  IRETnnWW (nn: 62 or higher)


What This Package Does
----------------------
This package provides the Command Prompt Utility program (PS2.EXE) for
the following utilities, which runs in the MS-DOS Command Prompt
environment under Windows NT:

  - Power Management
  - Built-in Device Configuration
  - Display Device Controls

This package enables or updates the Command Prompt Utility program of
the following ThinkPad computer:

  - ThinkPad 240

To determine if you have to update the Command Prompt Utility program
or not, please refer to the "Summary of Changes" section.

To update the Command Prompt Utility program, please refer to the
"Installation Guide" section.


Released Versions
-----------------
Version 1.02     Initial release for ThinkPad 240


Summary of Changes
------------------
Where: <n.nn>  Package version (for example, 1.00 means Version 1.00)
       (New)   New function or enhancement
       (Fix)   Correction to existing functions

<1.02>
 - (New) Support for ThinkPad 240.


Installation Guide
------------------
(Note)
To determine if you have to update the Command Prompt Utility program
or not, please refer to the "Summary of Changes" section.

 1. Start Windows NT.
 2. Extract this package to the hard disk.
 3. Click on 'Start' -> 'Run...'.
 4. Type "C:\DRIVERS\WNT\UTILITY\SETUP.EXE" and press 'OK'.
 5. Follow the instructions on the screen.
 6. Restart the computer for the changes to take effect.

-Type  PS2 ?  at the command prompt, then press Enter to refer to the
 usage.
-Command Prompt Utility program can also be installed from a command
 prompt window.
-Silent installation:
    Use 'SETUP.EXE -S' command at the step 4.


Trademarks
----------
  * IBM and ThinkPad are registered trademarks of IBM Corporation.
  * Windows is a registered trademark of Microsoft Corporation.

  Other company, product, and service names may be registered trademarks,
  trademarks or service marks of others.