AST VGA Plus                                        AST Part Number 202262-001

The VGA Plus is a Video Graphics Array video adapter for use with the IBM PC,
PC/XT, PC/AT, and 100% compatible machines.  This board can operate in either
8-bit or (in an AT compatible) 16-bit mode. It comes standard with 256K of
video memory (expandable to 512K) and a 15-pin connector for sending analog
video signals to a PS/2, VGA, or Multisynch monitor.  Video modes supported by
the VGA PLUS are MDA, HGC, CGA, EGA, and VGA, all on analog monitors.


SWITCH SETTINGS

    There is one bank of four switches accessable through the rear bracket
    of the board.  They control the following features:

    SW1  ON - Monitor attached is a multisynch operating in analog mode.
        OFF - Monitor attached is a PS/2 or other analog display.

    SW2  ON - Data transfer rate is 16-bit (board must be in 16-bit slot).
        OFF - Data transfer rate is 8-bit.

    SW3  ON - Adds one wait state to buss speed.
        OFF - Board operates at speed of buss.

    SW4 OFF - AT ALL TIMES


SWITCH BLOCK LOCATION

    +-----------------------------------------+
    |                                         | +---
    |                                       +-+-+
    |                                    SW1| | |
    |                                       +-| |
    |                                         | |
    |                                         | |
    |                                         | |
    |                                         | |
    |                                         | |
    |                                         +-+
    +---------------+      +-+             +--+ |
                    +------+ +-------------+    |
                                                |